Digital View DVR-810 Manual de instrucciones descargar pdf (Pagina 49)

Diagram 3.9

Diagram 3.9 is a screen shot of the VIDEOLOSS SETUP MENU. VIDEOLOSS event is caused

when no video signal input is detected on a channel. Usually it happens when the camera loses

power or the camera fails. In the VIDEOLOSS SETUP MENU the following fields are defined

as follows:

1. VIDEOLOSS:

ENABLE: Enable video loss detection.

DISABLE: Disable video loss detection.

2. LOG:

ON: Select ON if you wish to record Video Loss Events in the Log.

OFF: Select OFF if you do not wish to record Video Loss Events in theLog.

3. DURATION: The amount of time a Video loss event will record - from 1 sec to 99 seconds. The

default value is 5 seconds. To change this, simply use the Jog Dial on the DVR.

4. ALARM OUTPUT: This will transmit a signal to another device. The setting of alarms are

NONE = not activated, 1 = output signal 1 transmitted. To change this, simply use the Jog Dial

on the DVR.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 149 150

Sin comentarios

Digital View DVR-810 Manual de instrucciones Pagina 49